|
TI公司的AFE4110是基于超低功耗MSP430 RISC處理器,配置有兩個16位計時器,48段LCD驅動器,可編程模擬池,電源監視器和基準電壓源,特別適合采用單顆SR60電池的低成本數字溫度計,工作電壓1.1V-1.55V,3mA 1.85V內部電荷泵用于外接EEPROM和內部LCD驅動器,工作時功耗45µA/MHz (1.55V),深度睡眠功耗小于0.4µA,主要用于數字溫度計,計步器,溫度調節器和其它手持設備.本文介紹了AFE4110主要特性,功能框圖,AFE4110溫度計演示板主要特性,電路圖,材料清單和PCB元件布局圖. The Texas Instruments MSP430 family of low-power mixed signal ASSPs consists of many devices featuring different sets of peripherals targeted for various consumer medical applications. The AFE4110 CPU architecture is based on the popular ultra low power Texas Instruments MSP430 RISC processor. The AFE4110 configuration with two 16-bit timers, integrated 48-segment LCD driver, programmable Analog Pool, supply voltage monitor and internal reference voltage source is particularly well suited for implementation of low cost digital thermometers operating from a single cell SR60 battery. The capability to correct the on chip high frequency oscillator output facilitates the generation and measurement of real time intervals. For many applications, this capability allows system designers to eliminate a clock crystal from the system BOM. AFE4110主要特性: Ultra Low Supply-Voltage (ULV) Range 1.1V - 1.55V Unregulated Single Cell Battery Operation(CPU, System Core, and Timers)3mA 1.85V Internal Charge Pump for External EEPROM (R/W),VDDIO, and Internal LCD Controller 60µA 3.3V Regulated Charge Pump for LCD Drive Pads Low Power Consumption Active Mode (AM): 45µA/MHz (1.55V) Standby Mode (LPM3, LCD): < 25µA Deep Sleep Mode (LPM5):<0.4µA 8-Bytes Battery Backed RAM for Calibration Retention Wakeup From Periodic Timer or External Interrupt Wake-Up from LPM5 in 10ms, Wake-Up from LPM4 in 5µs 16-Bit RISC Architecture Extended Instructions 125ns Instruction Cycle Time Compact Clock System Internal Trimmable High Frequency Clock Oscillator with Discrete Frequency Selections Between 1MHz and 5.4MHz 20kHz Internal low Frequency Clock Oscillator External Clock Input (Upto 8MHz) 32kHz Crystal Oscillator Internal High Frequency Oscillator Frequency Correction Facilitates Generation and Measurement of Real Time Intervals Without a Clock Crystal Utilizes Factory Calibration (E-Fuse), S/W, and a Single External 1Mύ Resistor Integrated LCD Controller Drives 4-Mux, 3-Mux, 2-Mux, or Static Mode LCDs Up to 48 (4x12) LCD Segments Two 16-Bit Timer0_A3 with Three Capture/Compare Registers Extended Input Multiplexer for High Accuracy RC Discharge Measurement ULV Analog Pool 8-Bit Analog-to-Digital Converter (ADC) 8-Bit Digital-to-Analog Converter (DAC) Programmable Comparator (COMP) Supply-Voltage-Monitoring (SVM) Internal Temperature Sensor Internal Voltage Reference 1V Regulated (LDO) Outputs 32-Bit Watch-Dog-Timer (WDT-A) 21-Configurable Analog I/O or Digital GPIO Pads, 2-Power GPIO for 10mA VDD/1.85/3.6V Buzzer Load 10-GPIO for VDDIO Operation with VDD/1.85/ 3.6V Internal Level Shifting 11-GPIO for VDD Operation (1.1V – 1.55V) 4-Regulated 1V (LDO) Analog Outputs 1-250mV DAC Analog Output 6-Analog Comparator/ADC Inputs SPI EEPROM Bootstrap Loader (AFE4110A) Full Four Wire JTAG Debug Interface AFE4110應用: • For any application requiring a full analog LCDs signal chain and an LCD display driver such as digital thermometers, pedometers, thermostats, and other portable single alkaline battery devices. 
圖1.AFE4110功能方框圖 AFE4110溫度計演示板 This user’s guide provides a general description of the AFE4110 thermometer demonstration board (demo-pen). Use this document with the AFE4110 data sheet to get a broader understanding of the functions and applications of this device. The board demonstrates an accurate, low-cost, single-chip temperature measurement solution based on the AFE4110. This device is a general-purpose, low-cost, 1.5-V microcontroller optimized for this application with features like an internal 1.85-V/3.3-V charge-pump for LCD/GPIO interface, buzzer driver, low-power sleep mode, etc. The measurement is done using an external thermistor with a negative temperature coefficient (NTC) characteristic (resistance decreases with increasing temperature). The thermistor response has been calibrated using two temperature points (at 31°C and 43°C), for an overall typical accuracy of ± 0.1°C over that range, when measured in a calibration bath.
圖2.AFE4110溫度計演示板外形圖:正面(底層)和背面(頂層)
圖3.AFE4110溫度計演示板電路圖(1)
圖4.AFE4110溫度計演示板電路圖(2)
圖5.AFE4110溫度計演示板電路圖(3)
圖6.AFE4110溫度計演示板電路圖(4)
圖7.AFE4110溫度計演示板電路圖(5) AFE4110溫度計演示板材料清單(BOM):
圖8.AFE4110溫度計演示板元件布局圖:頂層
圖9.AFE4110溫度計演示板元件布局圖:底層 詳情請見: 
sllse48.pdf
(1.69 MB)
slau417.pdf
(344.46 KB)
來源：網絡 |
